Microha? MK2R+ Manuel d'utilisateur télécharger pdf (Page 9)

AFSK with MMTTY:

N1MM Logger supports the MMTTY Engine, MMVARI and/or an external TNC for RTTY contesting. This

configuration is based on using MMTTY in AFSK mode.

AFSK does not require a digital port for each radio. If you will be using only AFSK and PSK, it is not

necessary to define "Digital" ports on the N1MM "Hardware" tab or FSK ports in Router.

1. Install MMTTY in two

different

directories on your hard disk.

2. Select the Digital Modes tab in the

N1MM Logger Configurer.

3. Set the TU Type to Soundcard

4. select AFSK as the MMTTY mode for

both DI-1 and DI-2.

5. Enter the path to each copy of

MMTTY.

6. Open the Mode Control tab

7. Set the appropriate RTTY and PSK

modes for each radio.

Note: See the N1MM Logger Help

files for the supported RTTY and PSK

modes for your radios.

8. Set the method to determine the

mode recorded in the log.

9. Save and Close the Configurer.

10. Activate the left Entry Window (Radio

1) and open the Digital Interface.

11. If this is the first time you have used the MMTTY interface, click on Interface | MMTTY to activate the

MMTTY interface.

12. In the Digital Interface, Click Setup | Setup MMTTY.

13. Select the "SoundCard" tab.

14. Set Reception and Transmission

to USB Audio CODEC for MK2R+

or the sound card connected to

the “SC1” jacks for MK2R.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Microha? MK2R+ Manuel d'utilisateur Page 9